With the switch interface Philippi CMR 4 5 different control functions can be executed:
Controlling an AC generator
Visualization of alarm messages
Control of pumps in case of tank alarm
The configuration of the switch interface Philippi CMR 4 is done via the Philippi PSM2.
Dimensions : L 115 x W 105 x H 50 mm
Monitoring the bilge pump function is a new additional feature of the Philippi Switch Interface Philippi CMR 4 that logs the activity of one or more bilge pumps and displays it on the Philippi System Monitor PSM2. The relay module Philippi CMR 4 is switched between float switch and bilge pump. Depending on the setting, the Philippi CMR 4 only logs the function of the bilge pump or reports the alarm of the bilge sensor, and the bilge pump must then be activated manually via the motor.
The Philippi System Monitor PSM 2 displays the status of the bilge pump as follows:
- Bilge white: Bilge pump is switched off, no alarm
- Bilge flashing red: Bilge pump is switched off, an alarm has been triggered.
- Bilge green: Bilge pump in operation
The operating time in minutes of the current day is displayed above the bilge symbol. Below the bilge symbol, the number of power-ups in the current hour and day. These counters are set to 0 when a new day or hour starts.
The symbol also serves as a button:
- A long press of approx. 2s switches the bilge pump on or off.
- A short touch opens a page with a statistical evaluation of the use of the bilge pump.
The monthly average values of the switch-on procedures and the operating times are also displayed here. With the "Reset" button, all values can be reset to 0 once the system pin has been successfully entered.