The combined digital Philippi battery and tank monitor BTM is the successor of the well-known and successful Philippi battery monitor series BCM and the Philippi tank monitor TCM.
Its 3.5-inch color touch screen graphic display provides an overview of the battery system status and the level of up to four tanks and shows the status of the ACE charger during operation. It allows the connection of a Philippi battery shunt SHE 300 for battery monitoring, the direct connection of 4 tank sensors and the connection of an automatic charger ACE via the interface ACE-LIN.
Suitable for all battery types such as acid, GEL, AGM and LiFePO4.
Precise battery information on the current voltage, charging or discharging current, remaining time, temperature and state of charge of the consumer battery. Statistical values for the number of charge cycles, deep discharges and average discharge depth give you an overview of the use of the battery. It is possible to monitor the voltage of up to 2 starter battery banks. For further monitoring, individual alarms such as a battery reserve threshold can be defined.
All known philippi tank sensors such as TGT/TGW, UTV, TDS/TDW and DFS can be connected, even existing tank sensors from other manufacturers with the signals 10-24033Ω / 24033Ω / 0-5 V / 0-10 V/ 4-20 mA are possible. Each tank can be individually configured for unambiguous assignment, and adaptation to non-linear tank geometries is also possible. For monitoring purposes, individual minimum or maximum alarm thresholds can be defined for each tank.
An ACE-LIN interface integrated in the ACE automatic charger allows the monitoring of the charging process, the display of the mains voltage, the charging phase, the battery temperature and the charging current. Setting of power and silent mode (fan off). Individual minimum or maximum alarm thresholds per tank can be defined for monitoring purposes.
An adjustable alarm warns in time of a dangerous deep discharge of your batteries, empty tanks or batteries that are too hot. In addition to the text display, the alarm message can also be output on the internal buzzer as well as on the integrated potential-free relay.
Simple installation: The connection between monitor and shunt consists of a single line, even an existing line can be used. - All tank sensors are connected on the back of the monitor.
Dimensions: W 105 x H 105 x D 70 mm
Installation cut-out: 88 x 88 mm
Operating voltage: 8-32 V
Current consumption: max. 70 mA @ 12V, stand-by: 6 mA